Multi-line 2 ALC Application Software series 4x

4.13.0

15/06/2021

PM compatibility version 1.23.1.

New features:

• Load-groups are now able to close on a dead busbar in AUTO mode. This can be activated via Modbus commands, Modbus control register or M-Logic.
• Eight low frequency alarms are added. These are placed in menus 1000-1070.

Changes:

• Faster execution of load-groups closing.
• Four output relays on terminals 118-119, 118-120, 121-122 and 123-124 are now configurable.

4.12.0

26/11/2020

PM compatibility version 1.21.0.

New features:

•    Configurable amount of units for triggering Fatal CAN Error alarm is added in menu 8800.

Changes:

•    Support of ASC-4 redundancy.

Corrections:

•    Corrected that selection of ‘Number of PMS units’ and ‘PMS CAN baud rate’ previously would only work with default settings. and an issue with redundancy.

4.11.0

13/02/2020

PM compatibility version 1.16.0
Includes version 1.15.0

New features:

•    Now possible to open and close LG's while position failure is present.
•    Block LG fail classes added
        • Position failure alarms set default to LG Block fail class.

Corrections:

•    Corrected ALC Breaker Feedback Emulation.

4.10.1

10/01/2020

PM compatibility version 1.16.0

Corrections:

•    Horn relay now working
•    M-Logic PMS flags for GB/MB closed now working 
•    LG(load group) pos. fail alarm now possible when LG is disabled

4.10.0

12/12/2019

PM compatibility version 1.16.0

Features:

•    32 DG/Mains support
        • Support of 32 DG's in ID range 1-32 (AGC-4/200, version 4.65.0 required).
        • Support of 32 Mains in ID range 1-32 (AGC-4/200, version 4.65.0 required).
        • Support of 16 ASC's in ID range 25-40 (ASC-4, version 4.06.0 required).
        • Support of  8 ALC's in ID range 25-40.
•    Support of ASC PV and Battery.
•    Heavy Consumer logic added.
•    Flip/Flops added to M-logic.

Changes:

•    Disconnect Load can now be set to 200 % and 999 sec.

Corrections:

•    Corrected: Tripped open relay hanging on redundant unit.
•    Corrected: LG's are not opened in AUTO mode when disabled.
•    Corrected: Digital input alarms are not activated by input.

4.00.1

29/01/2018

Corrections:

• In some instances, all fail classes were initialised to "Shutdown" unintentionally.

4.00.0

30/10/2017

PM compatibility version 1.15.0
  
Features:
1- Includable in Power Management application type "Standard" together with AGC-4 and AGC 200.
a) Up to 16 gensets.
  b) Up to 16 mains.
c) Up to 8 BTBs/ALCs in plants.
d) Spinning reserve support.
2- Able to close and open breakers according to available power from DG. 
3- Able to place the ALC in mains load point.